I have a 2023 Honda Passport that I couldn’t tilt the seat far enough forward. After driving a little while, the back of my legs where the edge of the seat hits them, it would get sore. I’m so glad I found Desert Does It. The rear seat jackers did the trick.
Thanks
Dave T
K
Ken (Nampa, ID, US)
Great Product
I am 5'6" so I also intalled the rear seat jacker in my truck. It does make a big difference. I can see the road better and my legs remove the stress that is normally on my lower back.
G
Greg M. (Atlanta, GA, US)
Good product that worked for new CRV
Good kit. Got with the 96-02 4Runner front spacer kit to go on our 2025 Honda CRV passenger seat, as reported on a CRV forum, as the seat is too low for us shorter folks. Only had to buy new M10 bolts (button head) as the provided bolts were too tall to allow the seat to slide back.
I finally got the chance today to install my seat slammers and I couldn’t be happier. I don’t have to duck to get in my gladiator anymore and I don’t hit my head on the sound bar. It gives the truck a totally different feel now behind the wheel. I highly recommend this to anyone.
Nicely presented and packaged + product arrived in a timely manner. Having installed them in my 19 Tundra the seating position has become a lot more comfortable. I’m finally feeling somewhat supported in the seat. Thanks
Fitment problems on Ram 2500 Tradesman 40/20/40 split bench seat
Driver side aft position seat jackers worked fine (the two seat bolts dedicated to the driver seat accommodated the spacers). However, of the two aft passenger seat bolts, the one nearest to center has a support bracket providing support for the center bench seat. With that seat bolt removed, I was able to pry it enough to fit the jacker (spacer) but could not get the bolt to thread - even with a lot of force. I partially stripped the Jacker bolt because the bolt could not be lined up with the spacer in place and it wore on the bolt. I was afraid I would strip the welded nut in the floor, so I just removed the Passenger side jackers and re-installed the OEM bolts without the lift spacers. The directions indicate that some prying may be required, but in my case, the amount of prying and potential bending/deformation to the passenger seat support frame / center split seat bracket was way beyond reasonable. Happy with driver side seat jacker, but I'd avoid using these for passenger side in my Ram seat configuration.
