REAR SEAT JACKERS (RAM, JEEP, DODGE)

INSTALL INFO

FITS

2019 - 2025 Ram 1500 (5th gen only will not fit Classic)
2011 - 2021 Jeep Grand Cherokee
2011 - 2025 Dodge Durango

DIFFICULTY

Tools Needed

E12 E-Torx and Ratchet
6mm Allen Key or Socket
Torque Wrench

Included Parts

2 - M10 1.5 x 60mm - Cap Head Bolts
2 - M10 Washers
4 - .5" Shims (two per side)
Blue Loctite

IMPORTANT NOTES

Desert Does It will not be liable for any loss, damage, or injury directly or indirectly from the use or the inability to determine the use of these products. Before using or installing, the user shall determine the suitability of the products for its intended use, and the user shall assume all responsibility and risk in connection therewith. Any modifications to your vehicle are done at your own risk.

INSTALLATION INSTRUCTIONS

Installation Instructions:

General Note: To help prevent cross threading during installation, we recommend verifying bolts and threads by taking the applicable bolts and threading them in by hand to the corresponding hole.

Step One: Remove any plastic trim at the feet of your seat. Remove both rear factory seat base bolts (E12 E-Torx) and loosen the two front seat bolts but do not remove them.

Step Two: From the back seat, lift the rear of the front seat by pushing forward on the headrest or by asking a helper to pull from the front.

Step Three: Place desired number of Seat Jacker Shims under the rear of the seat, in between the seat rails and the floor. Notch in the Seat Jacker will face under the seat.

Step Four: Take the Blue Loctite and apply it to the provided 60mm bolt, add washer (if needed) and attach the rear seat legs to the floor.

Step Five: Torque front bolts and rear bolts to 35 ft-lbs.

IMPORTANT – IF THE SEAT RAIL HOLE DOES NOT LINE UP, LIFT UP THE SEAT RAIL .25 INCHES AND THREAD IN THE BOLT A COUPLE OF THREADS. IF NEEDED ADJUST THE SEAT RAILS ONE AT A TIME TO LINE THEM UP.

SHOPPING CART

title