Jeep / RAM Multi Mount Panel (2011 - 2021 Jeep Grand Cherokee / 2019 - 2025 RAM 1500 / Dodge Durango 2011 - 2025) — Install Guide

Important Note

To help prevent cross-threading during installation, verify bolts and threads by taking the applicable bolts and threading them into the corresponding holes by hand. Do not force the bolts.

Step 1 — Prepare the Seat

1. When applicable, remove the bolt trim pieces at the seat base using a pry tool or screwdriver.
2. If desired, use a step bit or 1" hole saw to drill out holes in the plastic trim to allow the MMP brackets to pass through.

Step 2 — Remove the Factory Bolts

1. Slide the seat all the way back.
2. Remove both front factory seat base bolts.

Step 3 — Install the MMP Brackets

1. Apply Blue Loctite to the two new BLACK flathead bolts.
2. Thread the black flathead bolts through each MMP Bracket, through the seat rail, and into the threaded holes in the floor.
3. Roughly align the flat face of the brackets so they are facing forward.
4. Hand-tighten the black flathead bolts only at this time.

Step 4 — Install the Multi-Mount Panel

1. Using the two new STAINLESS STEEL flathead bolts, mount the Multi-Mount Panel to the MMP Brackets.
2. Hand-tighten the stainless steel flathead bolts only at this time.

Step 5 — Align and Torque

1. Align the Multi-Mount Panel as desired.
2. Torque the two BLACK flathead bolts to 25ft-lbs.
3. Torque the two STAINLESS STEEL flathead bolts to 15ft-lbs.

Final Check

• Verify all four bolts are properly installed and torqued.
• Confirm the MMP brackets are securely mounted to the vehicle floor.
• Confirm the Multi-Mount Panel is properly aligned and secure.

Desertdoesit.com - Check bolt torque at regular intervals and don’t forget to post a review."