RAM / Jeep / Dodge Front Seat Jackers® (2019-2025 RAM 1500 / 2011-2021 Jeep Grand Cherokee / 2011-2025 Dodge Durango)

General Note: To help prevent cross threading during installation, we recommend verifying bolts and threads by taking the applicable bolts and threading them in by hand to the corresponding hole.

• Step One: Remove plastic trim from seat base bolts, remove both front factory seat base bolts (E12 E-torx) and loosen the two rear seat bolts but do not remove them.
  *These factory bolts will be reused in Step Three in the same location.
• Step Two: Lift the front of the front seat by pushing back on the headrest or by asking a helper to sit in the back seat and gently pull the headrest towards them.
• Step Three: Place Seat Jackers under the front seat mounts (DDI engraving faces forward). With Blue Loctite, use the factory bolts to fasten the Seat Jackers to the floor of the vehicle (thread through round inset hole in Seat Jackers). Torque bolts to 27ft-lbs.
  *IMPORTANT - THE FACTORY BOLTS ARE USED TO FASTEN THE BLOCKS TO THE FLOOR.
• Step Four: With Blue Loctite, use the provided M10-1.5 x 25mm bolts (black flange bolts) to fasten the seat to the Seat Jackers, finger tight only.
  *IMPORTANT – IF THE SEAT RAIL DOES NOT LINE UP, LIFT UP THE SEAT RAIL .25 INCHES AND THREAD IN THE BOLT A COUPLE OF THREADS. IF NEEDED ADJUST THE SEAT RAILS INDEPENDENTLY TO GET THEM LINED UP.
• Step Five: Torque the two front bolts and two rear bolts to 27ft-lbs.