Nissan Multi Mount Panel (2017+ Titan / 2017-2024 Armada / 2022+ Frontier) — Install Guide
- Nissan Titan '17+
- Nissan Armada '17–'24
- Nissan Frontier '22+
Fits
- 2017+ Nissan Titan
- 2017-2024 Nissan Armada
- 2022+ Nissan Frontier
Included Parts
- 2xM8 x 16mm Button Head Bolts
- 2xM10 1.25 x 30mm Socket Head Bolts
- 2xMMP Brackets
- 1xMMP
- 1xBlue Loctite
Tools Needed
- Ratchet and 14mm Socket
- 5mm and 8mm Allen Key and Socket
- Torque Wrench
Installation Difficulty
2 of 5
Installation Instructions
Important Note
To help prevent cross-threading, always start bolts by hand and verify they thread smoothly into the corresponding hole before tightening.
Step 1 — Remove Seat Base Trim
- When applicable, remove the bolt trim pieces at the seat base using a pry tool or screwdriver.
Step 2 — Remove Factory Seat Bolts
- Slide the seat all the way back.
- Remove both front factory seat base bolts.
Step 3 — Attach the Panel to the MMP Brackets
- Using the stainless steel hardware, loosely mount the panel to the MMP brackets.
- Do not fully tighten the stainless steel hardware at this time.
Step 4 — Install MMP Brackets
- Apply Blue Loctite to the two new black socket head bolts.
- Thread the black socket head bolts through each MMP bracket, through the seat rail, and into the threaded holes in the vehicle floor.
- Start both bolts by hand and leave them loose for alignment.
Step 5 — Align and Torque
- Align the panel and MMP brackets.
- Torque the two black socket head bolts to 30ft-lbs.
- Torque the two stainless steel bolts to 15ft-lbs.
Final Check
• Verify the panel and brackets are properly aligned.
• Confirm all four bolts are properly torqued.
• Check bolt torque at regular intervals.
Desertdoesit.com - Check bolt torque at regular intervals and don’t forget to post a review.



