HONDA REAR SEAT JACKERS (2013-2024 Accord / 2016 - 2024 Civic

INSTALL INFO

FITS

2013 - 2024 Honda Accord
2016 - 2024 Honda Civic

DIFFICULTY

Tools Needed

T50 Torx
6mm Allen Key or Socket
Torque Wrench

Included Parts

2 - M10 1.25 x 50mm - Button Head
2 - M10 Washers
4 - .5 Inch Shims
Blue Loctite

IMPORTANT NOTES

Desert Does It will not be liable for any loss, damage, or injury directly or indirectly from the use or the inability to determine the use of these products. Before using or installing, the user shall determine the suitability of the products for its intended use, and the user shall assume all responsibility and risk in connection therewith. Any modifications to your vehicle are done at your own risk.

INSTALLATION INSTRUCTIONS

Installation Instructions:

Step One: Remove any plastic trim at the feet of your seat. Remove both rear factory seat base bolts (T50 Torx) and loosen the two front seat bolts but do not remove them.

Step Two: lift the rear of the seat by pushing forward on the headrest or asking someone to lift or pull backwards.

Step Three: Place desired number of spacers under the rear of the seat, in between the seat rails and the floor.

Step Four: Take the provided 50mm bolt and washer (If needed) and attach the rear seat legs to the floor. *IMPORTANT – IF THE SEAT RAIL HOLE DOES NOT LINE UP, LIFT UP THE SEAT RAIL .25 INCHES AND THREAD IN THE BOLT A COUPLE OF THREADS. IF NEEDED ADJUST THE SEAT RAILS ONE AT A TIME TO GET THEM TO LINE UP.

Step Five: Torque front bolts and rear bolts to 27 ft-lbs.

Check bolt torque at regular intervals and don’t forget to post a review.

SHOPPING CART

title