• Home to the ORIGINAL Seat Jackers
  • Lifetime Guarantee
  • FAST & FREE shipping (USA)
What are you Looking for?
SHOPPING CART

No Products in the Cart
TOTAL:
$0.00
PROCEED TO CHECKOUT
VIEW CART
img

title

  • details
qty X
price

GM Seat Jacker Installation Instructions 2014 - 2018 GM 1500, 2015 - 2019 GM 2500 / 3500 2015 - 2020 Chevy Suburban / Tahoe / Yukon *2015-2022 Chevy Colorado / GMC Canyon

INSTALL INFO

FITS

2014 - 2018 GM 1500  

2015 - 2019 GM 2500 / 3500

2015 - 2020 Chevy Suburban / Tahoe / Yukon

2015-2022 Chevy Colorado / GMC Canyon

DIFFICULTY

Tools Needed

  • T50 Torx
  • Blue Loctite  
  • Torque Wrench

Included Parts

  • Two Hook Style Seat Jackers

 

IMPORTANT NOTES

Desert Does It will not be liable for any loss, damage, or injury directly or indirectly from the use or the inability to determine the use of these products. Before using or installing, the user shall determine the suitability of the products for its intended use, and the user shall assume all responsibility and risk in connection therewith. Any modifications to your vehicle are done at your own risk.

INSTALLATION INSTRUCTIONS

Installation Instructions:


General Note: You will reuse the factory rear bolts. Be sure to use Blue Loctite when reinstalling the factory rear bolts. We recommend having a helper with this installation as it requires lifting the seat. 


*COLORADO/CANYON ONLY

SMALLER NOTCHED BLOCK INSTALLS ON THE TRANS TUNNEL SIDE


  • Step One:  When applicable, remove trim pieces at the seat base. In the front, be very careful as the trim tabs can break very easily. You will only need to remove the door side trim.
  • Step Two:  Slide the seat all the way to the front and remove the torx bolt at the rear of each seat rail. Door side is under the carpet..
  • Step Three: The front of the seat hooks in the front so you will need to press forward by the headrest and push backwards at the front of the seat while lifting to unhook the front of the seat. Reference pictures on product listing on DesertDoesIt.com.
  • Step Four:  Have a helper sit in the back and hold the seat so the front mounting hooks are about 6 inches off the floor. Attach the provided Seat Jackers by sliding them onto the front of your seat rail where the existing hooks are located. The hooks on the Seat Jackers will be facing the same way as the factory hooks. 
  • Step Five:  Once the Seat Jackers are on, lift and set your seat back into the floor making sure the Seat Jackers hook into the floor and rear seat rail should sit back down in the same location. Using Blue Loctite, torque the factory seat bolts back down to 30 ft-lbs.

        Check bolt torque at regular intervals and don’t forget to post a review. 

 

 

BACK TO TOP