• Home to the ORIGINAL Seat Jackers
  • Lifetime Guarantee
  • FAST & FREE shipping (USA)

GM MMP Installation Instructions 2014-2018 Chevy Silverado/GMC Sierra 1500 2015 - 2019 GM 2500 / 3500 2015 - 2020 Chevy Suburban / Tahoe 2015-2022 Chevy Colorado/GMC Canyon



2014 - 2018 GM 1500

2015 - 2020 Chevy Suburban / Tahoe

2015 - 2019 GM 2500 / 3500

2015 - 2022 Chevy Colorado / GMC Canyon


Tools Needed

  • 3mm and 5mm Ball-End Allen Key or Socket
  • Blue Loctite  



Included Parts

  • 4 - M8 x 16mm - Button head - SS
  • 4 - M6 1 x 8mm - Set Screw  - SS
  • 2 - Brackets  (Sku 5308)
  • 1 - MMP  (Sku 5307)




Desert Does It will not be liable for any loss, damage, or injury directly or indirectly from the use or the inability to determine the use of these products. Before using or installing, the user shall determine the suitability of the products for its intended use, and the user shall assume all responsibility and risk in connection therewith. Any modifications to your vehicle are done at your own risk.


Installation Instructions:

General Note: To help prevent cross threading during installation, we recommend verifying bolts and threads by taking the applicable bolts and threading them in by hand to the corresponding hole.

  • Step One:  When applicable, remove trim pieces at the seat base.
  • Step Two:  Slide seat all the way to the rear and remove the torx bolt at the front of each seat rail (See tools needed above).
  • Step Three: Take each MMP bracket block and slide it UNDER each seat rail so that block portion is hanging off the front. With blue loctite, loosely rethread the factory bolts back through the seat rails through the MMP brackets and into the floor. *Reference pictures on website product listing for more details.
  • Step Four:  With the provided STAINLESS STEEL button heads, loosely affix the multi mount panel to the front of the MMP brackets (the taller side of the panel will be nearest the door).
  • Step Five:  Confirm panel and blocks are aligned and torque the factory seat bolts to 27ft-lbs.
  • Step Six:  Tighten the STAINLESS STEEL button heads on the front of the panel and reinstall any plastic trim pieces.