GMC / Chevy Multi Mount Panel (2019+ Chevy Silverado, 2019+ GMC Sierra) 2021-2024 Chevy Suburban / Tahoe, 2020 - 2024 GM 2500 / 3500

INSTALL INFO

FITS

2019+ Chevy Silverado
2019+ GMC Sierra
2021-2024 Chevy Suburban / Tahoe
2020 - 2024 GM 2500 / 3500

DIFFICULTY

Tools Needed

T45 or T50 Torx
5mm Ball-End Allen Key or Socket
Blue Loctite
Torque Wrench

Included Parts

2 - M8 x 16mm - Button head - SS
2 - Brackets (Sku 5302)
1 - MMP (Sku 5301)

IMPORTANT NOTES

Desert Does It will not be liable for any loss, damage, or injury directly or indirectly from the use or the inability to determine the use of these products. Before using or installing, the user shall determine the suitability of the products for its intended use, and the user shall assume all responsibility and risk in connection therewith. Any modifications to your vehicle are done at your own risk.

INSTALLATION INSTRUCTIONS

General Note: To help prevent cross threading during installation, we recommend verifying bolts and threads by taking the applicable bolts and threading them in by hand to the corresponding hole.

Step One: When applicable, remove trim pieces at the seat base.
Step Two: Slide seat all the way to the rear and remove the torx bolt at the front of each seat rail (See tools needed above).
Step Three: Take each MMP bracket block and slide it UNDER each seat rail so that block portion is hanging off the front. With blue loctite, loosely rethread the factory bolts back through the seat rails through the MMP brackets and into the floor.
Step Four: With the provided STAINLESS STEEL button heads, loosely affix the multi mount panel to the front of the MMP brackets (the taller side of the panel will be nearest the door).
Step Five: Confirm panel and blocks are aligned and torque the factory seat bolts to 27ft-lbs.
Step Six: Tighten the STAINLESS STEEL button heads on the front of the panel and reinstall any plastic trim pieces.

SHOPPING CART

title