Ford Front Multi Mount Panel (2011-2016 Super Duty) — Install Guide
- Ford Super Duty '11–'16
Fits
- 2011-2016 Ford Super Duty
Included Parts
- 2xM8 x 16 mm - Button Head - SS
- 2xM12 1.75 x 80mm - Flathead - Blk
- 2xBrackets (sku 3304)
- 1xMMP (sku 3301)
- 1xBlue Loctite
Tools Needed
- Ratchet with 21mm socket to remove factory seat base bolts
- 5mm and 8mm Allen Key or Socket
- Torque Wrench
Installation Difficulty
2 of 5
Installation Instructions
Important Note
To help prevent cross-threading during installation, verify the bolts and threads by taking the applicable bolts and threading them into the corresponding holes by hand. Do not force the bolts.
Step 1 — Remove Seat Trim
- When applicable, remove the bolt trim pieces at the seat base using a pry tool or screwdriver.
Step 2 — Remove Factory Bolts
- Slide the seat all the way back.
- Remove both front factory seat base bolts. Refer to the Tools Needed section.
Step 3 — Attach the Panel to the MMP Post Brackets
- Using the provided stainless steel hardware, loosely mount the panel to the MMP post brackets.
Step 4 — Install the MMP Brackets
- Apply Blue Loctite to the two new black flathead bolts.
- Thread the black flathead bolts through each new MMP bracket, through the seat rail, and into the threaded holes in the floor.
- Hand-tighten the black flathead bolts only at this time.
Step 5 — Align and Torque
- Align the panel as desired.
- Torque the two black flathead bolts to 45ft-lbs.
- Torque the two stainless steel flathead bolts to 15ft-lbs.
Final Check
• Confirm the panel is properly aligned.
• Confirm the two black flathead bolts are torqued to 45ft-lbs.
• Confirm the two stainless steel flathead bolts are torqued to 15ft-lbs.
• Confirm all applicable trim pieces have been reinstalled.
DesertDoesIt.com - Check bolt torque at regular intervals and don’t forget to post a review.



