Ford Front Multi Mount Panel w/ Brackets (2020 - 2023 Explorer)
Installation Instructions
General Note: To help prevent cross threading during installation, we recommend verifying bolts and threads by taking the applicable bolts and threading them in by hand to the corresponding hole.
- Step One: When applicable, remove trim pieces at the seat base using a pry tool or screwdriver.
- Step Two: Remove both front factory seat base bolts.
- Step Three: With the stainless STAINLESS STEEL hardware, loosely mount the panel to the MMP brackets. The tabs on the brackets should be facing out so the brackets hug the legs at the seat base.
- Step Four: With blue loctite, thread the new BLACK flathead bolts through each bracket, spacer, and seat mount into the floor.
-
Step Five: Align panel and torque the two BLACK flathead bolts to 27ft-lbs and the two stainless STAINLESS STEEL flathead bolts to 15ft-lbs.
*Note, ball-end allen key may be needed for bolts nearest the transmission tunnel.