• Home to the ORIGINAL Seat Jackers
  • Lifetime Guarantee
  • FAST & FREE shipping (USA)
What are you Looking for?
SHOPPING CART

No Products in the Cart
TOTAL:
$0.00
PROCEED TO CHECKOUT
VIEW CART
img

title

  • details
qty X
price

FCA Seat Jackers - RAM 1500 (2002-2018), RAM 2500/3500 (2002–2024) AND RAM 1500 ClassicV(2019-2024)

INSTALL INFO

FITS

  • 2002-2018 RAM 1500
  • 2019-2023 RAM 1500 CLASSIC
  • 2002-2024 RAM 2500/3500

DIFFICULTY

Tools Needed

  • 13mm, 15mm, and 18mm Socket or E12 E-Torx Socket
  • 5mm Allen Key
  • Torque Wrench
  • Blue Loctite  

Included Parts

  • 2 - M8 1.25 Flathead Bolts - Black
  • 2 - M8 1.25 Flange Bolts - Zinc
  • 2 - M8 Washers - Zinc
  • 2 - Seat Jacker blocks - Black

IMPORTANT NOTES

Desert Does It will not be liable for any loss, damage, or injury directly or indirectly from the use or the inability to determine the use of these products. Before using or installing, the user shall determine the suitability of the products for its intended use, and the user shall assume all responsibility and risk in connection therewith. Any modifications to your vehicle are done at your own risk.

INSTALLATION INSTRUCTIONS

General Note: To help prevent cross threading during installation, we recommend verifying bolts and threads by taking the applicable bolts and threading them in by hand to the corresponding hole and remember to use blue loctite on all hardware.


  • Step One: Remove plastic trim from seat base bolts, remove both front factory seat base bolts and loosen the two rear seat bolts but do not remove them. 
  • Step Two: Lift the front of the front seat by pushing back on the headrest or by asking a helper to sit in the back seat and gently pull the headrest towards them.
  • Step Three: With the front of the seat lifted off the front mounting points, take the supplied Black Flathead bolts and bolt the Seat Jackers to the floor of the truck (DDI engraving faces forward). Torque bolts to 25 ft-lbs.
  • Step Four: Carefully lower the seat onto the Seat Jackers. The lower holes on the Seat Jackers will provide .75 Inches of lift, the top holes will provide 1.25 Inches of lift. Use the provided Zinc Flange Bolts and Zinc Washers to fasten the seat to the Seat Jackers, finger tight only.  *IMPORTANT – IF THE SEAT RAIL DOES NOT LINE UP, LIFT UP THE SEAT RAIL .25 INCHES AND THREAD IN THE BOLT A COUPLE OF THREADS. IF NEEDED ADJUST THE SEAT RAILS INDEPENDENTLY TO GET THEM LINED UP.
  • Step Five: Torque the two Zinc Flange bolts to 25 ft-lbs and the rear bolts to 55 ft-lbs. Reinstall any removed plastic trim at this point.
  • Step Six: Sit down and get comfortable!

Desertdoesit.com - Check bolt torque at regular intervals and don’t forget to post a review. - Desertdoesit.com

 

BACK TO TOP