2013 - 2024 Subaru BRZ, 2022 - 2024 Toyota GR86 Front Seat Jackers

INSTALL INFO

FITS

2013 - 2024 Subaru BRZ

2022 - 2024 Toyota GR86

DIFFICULTY

Tools Needed

14mm Socket
12mm Socket
Torque Wrench

Included Parts

2 - M10 1.25 x 40mm - Flange
2 - M10 1.25 x 50mm - Flange
4 - .5 Inch Shims
Blue Loctite

IMPORTANT NOTES

Desert Does It will not be liable for any loss, damage, or injury directly or indirectly from the use or the inability to determine the use of these products. Before using or installing, the user shall determine the suitability of the products for its intended use, and the user shall assume all responsibility and risk in connection therewith. Any modifications to your vehicle are done at your own risk.

INSTALLATION INSTRUCTIONS

Installation Instructions:

Step One: Remove any plastic trim at the feet of your seat. Remove both front factory seat base bolts (12mm socket) and loosen the two rear seat bolts but do not remove them.

Step Two: lift the front of the seat by pushing back on the headrest or asking someone to lift or pull backwards..

Step Three: Place desired number of spacers under the rear of the seat, in between the seat rails and the floor.

Step Four: If using just the .5 Inch Shims, use the shorter 40mm Bolt. If using both Shims (1”), use the 50mm bolt. *IMPORTANT – IF THE SEAT RAIL HOLE DOES NOT LINE UP, LIFT UP THE SEAT RAIL .25 INCHES AND THREAD IN THE BOLT A COUPLE OF THREADS. IF NEEDED ADJUST THE SEAT RAILS ONE AT A TIME TO GET THEM TO LINE UP.

Step Five: Torque front bolts and rear bolts to 27 ft-lbs.

SHOPPING CART

title