Tools Needed:

• 5mm and 8mm Allen Key or Socket
• 14mm Socket and Socket Wrench

Installation Instructions:

• Step One: When applicable, remove trim pieces at the seat base.

• Step Two: Remove both front factory seat base bolts (14mm wrench/socket).

• Step Three: With the stainless steel hardware, loosely mount the panel to the MMP brackets.

• Step Four: With blue Loctite, thread the two new black sockethead bolts through each MMP Bracket into the seat base. Hand tighten only.

• Step Five: Algin panel and torque the two sockethead bolts to 30ftlbs and the two stainless steel flathead bolts to 15ftlbs or German Spec (good’ntight).

DesertDoesIt.com - Check bolt torque at regular intervals and don’t forget to post a review. - DesertDoesIt.com